FIBERCOMMinc.

FCPI 400 Series

Option 1

Option 2

FEATURES:

FIBERCOMMinc.'s FCPI series is a full duplex, multi-drop/point-to-point. dual mode (master/local switch selectable) communications interface for connecting fiber-optic cables to RS232 ports. The printed circuit board is designed to be used as a fiber-optic replacement for the 400 modem. Located at the front edge of the board are 6 LED's;) Receive 1 (Rl), Transmit 1 (Tl), Power-On (PWR), Anti- Stream (ASTR), Transmit 2 (T2) and Receive 2 (R2). LED's are not operational when the fiber-optic unit is on back-up (battery) power.

Near the front edge are two Emitters (El and E2)(LED type) and two Detectors (Dl & D2). NOTE: Design layout places both Detectors as the two inside devices and both Emitters on the outside. The primary port (JI) is the edge connector. The secondary port (J2) is the RJll connector. Power is supplied to the unit by the host thru the edge connector or by way of the on-board battery. Unplugging the unit from the host disconnects the battery. Three battery options are available and are switch selectable.

The following items are available:

A605	9 volt alkaline battery (AL)		A330	RJ11 Cable
A610	8.4 volt rechargeable NiCad (NI)

SPECIFICATIONS:

PC BOARD	Fiberglass 6.25" x 9.00"
	Termination in 22/44 edge connector
	Keyed 3/4-CD: 7/8-HJ
ELECTRICAL
	9 to 12 VDC < 40 MA (Quiescent)	Host (via J1)
	Connectors	ST (Standard)
	Battery (Options) < 25 MA (Quiescent)	9V Alkaline (AL)
		8.4V NiCAD (NI)
	Special Order Only	7.2V NiCAD (NII)
	Wavelength	850 NM Multi-mode
		1310 NM Single-mode
	Speed	300 - 19.2K Baud
	Anti-Streaming	1 second both channels
	Temperature Range	-35 degrees C to 70 degrees C
	Power Budget	15db

WARRANTY	One Year

[FCPB Series] [FCPI Series] [FCMB Series] [FCRM Series] [FCTS Series]
[History of FIBERCOMMinc.] [Why Fiber Optics?] [Contact Us]
[Products] [Home]